PT Cruiser L4-2.4L Turbo (2009)
c. Push the socket with the extension into the pump placing the socket on the hex built into the center of the water pump impeller.
6. While holding the power steering pump shaft from turning using a hex wrench in the pulley end of the shaft, tighten the water pump impeller
rotating the 1/4 inch drive extension clockwise using a ratchet. This will draw the water pump in toward the power steering pump. Tighten the
impeller to 26 Nm (19 ft. lbs.) torque.
7. Remove the 10 mm socket (4) , 1/4 inch extension and ratchet from the water pump. Remove the hex wrench.
8. Align the three pump fastener holes and install the three hex drive bolts with washers. Tighten the bolts to 26 Nm (19 ft. lbs.) torque.
9. Install assembly on the vehicle. See: Water and Power Steering Pump Assembly - Installation
Water and Power Steering Pump Assembly - Installation
2.0L/2.4L ENGINE
1. Apply MOPAR(R) Dielectric Grease to new O-ring before installation.
2. Install O-ring gasket in water pump body groove (3).
CAUTION: Make sure O-ring gasket is properly seated in water pump groove (3) before tightening screws. An improperly located O-ring may
cause damage to the O-ring, resulting in a coolant leak.
