PT Cruiser L4-2.4L Turbo (2009)
Crankshaft Main Bearing Seal: Service and Repair
Rear Crankshaft Oil Seal - Installation
INSTALLATION
CAUTION: If a burr or scratch is present on the crankshaft edge (chamfer), cleanup with 400 grit sand paper to prevent seal damage during
installation of new seal.
NOTE: When installing seal, no lube on seal is needed.
1. Place Rear Crankshaft Seal Guide 6926-1 (1) on crankshaft.
2. Position seal (2) over guide tool. Rear Crankshaft Seal Guide 6926-1 should remain on crankshaft during installation of seal. Ensure that the lip of
the seal is facing towards the crankcase during installation.
CAUTION: If the seal is driven into the block past flush, this may cause an oil leak.
