PT Cruiser L4-2.4L Turbo (2009)
Air Duct: Service and Repair
Floor Distribution Duct - Removal
REMOVAL
WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument
panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the
airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag
system. Failure to take the proper precautions could result in an accidental airbag deployment and possible personal injury or
death.
NOTE: LHD model shown in illustrations. RHD model similar.
RIGHT FLOOR DISTRIBUTION DUCT
NOTE: Illustration shown with front floor carpet removed for clarity.
1. Remove the instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel -
Removal.
2. Remove the screw (4) that secures the right floor distribution duct (2) to the right side of the HVAC housing (1).
3. Disconnect the right floor distribution duct from the HVAC housing outlet and the right rear intermediate floor duct (3).
4. Remove the right floor distribution duct from the vehicle.
LEFT FLOOR DISTRIBUTION DUCT
1. Remove the steering column opening cover See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Steering Column Opening Cover - Removal.
2. Disconnect the left floor distribution duct (1) from the HVAC housing (2) and remove the duct.