PT Cruiser L4-2.4L Turbo (2009)
9. Install the bolt (2) that secures the A/C discharge line to the A/C compressor. Tighten the bolt to 12 Nm (108 in. lbs.).
10. Install the upper radiator support See: Body and Frame/Radiator Support/Service and Repair/Radiator Upper Crossmember - Installation.
11. Evacuate the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Evacuate.
12. Adjust the refrigerant oil level See: Heating and Air Conditioning/Service and Repair/Refrigerant Oil Level.
13. Charge the A/C system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Charge.
A/C Liquid Line - Removal
REMOVAL
WARNING: Review safety precautions and warnings before performing this procedure See: Heating and Air Conditioning/Service
Precautions/Warning and See: Heating and Air Conditioning/Service Precautions/Caution . Failure to follow these instructions may
result in possible serious or fatal injury.
1. Recover the refrigerant from the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Recovery.
2. Raise and support the vehicle.
3. Remove the splash shield from the right side frame rail See: Body and Frame/Fender/Front Fender/Front Fender Liner/Service and Repair/Splash
Shield - Removal.
4. Remove the nut that secures the A/C liquid line (2) to the A/C condenser (lower port) (1).
5. Disconnect the A/C liquid line from the A/C condenser and remove and discard the O-ring seal.
6. Install plugs in, or tape over the opened liquid line fitting and the condenser port.
7. Lower the vehicle.
8. Remove the nut (2) that secures the A/C liquid line (outboard fitting) (4) to the accumulator tube tapping block (1).
9. Disconnect the A/C liquid line from the accumulator tube tapping block and remove and discard the O-ring seal.
10. Install plugs in, or tape over the opened liquid line fitting and the accumulator tube tapping block port.
