PT Cruiser L4-2.4L Turbo (2009)
-
Repair the PCM power supply circuit(s) for an open circuit or high resistance.
-
Perform the POWERTRAIN VERIFICATION TEST. See: Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/Verification Tests/Powertrain Verification Test
4. CHECKING THE PCM SWITCHED POWER SUPPLY CIRCUITS
1. Turn the ignition on.
CAUTION: Do not probe the PCM harness connectors. Probing the PCM harness connectors will damage the PCM terminals resulting in
poor terminal to pin connection. Install PCM Pinout Box 8815 to perform diagnosis.
2. Using a 12 volt test light connected to ground, check the PCM switched power supply circuits.
3. Wiggle test each circuit during the test to check for an intermittent open in the circuit.
NOTE: The test light should be illuminated and bright. Compare the brightness to that of a direct connection to the battery.
Is the test light illuminated and bright?
Yes
-
Go to 5.
No
-
Repair the PCM switched power supply circuit(s) for an open circuit or high resistance.
-
Perform the POWERTRAIN VERIFICATION TEST. See: Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/Verification Tests/Powertrain Verification Test
5. CHECKING THE PCM FUSED IGNITION SWITCH CIRCUITS
1. Turn the ignition on.
CAUTION: Do not probe the PCM harness connectors. Probing the PCM harness connectors will damage the PCM terminals resulting in
poor terminal to pin connection. Install PCM Pinout Box 8815 to perform diagnosis.
2. Using a 12 volt test light connected to ground, check the PCM Fused Ignition Switch circuits.
3. Check each circuit with the ignition on, engine not running position, and during cranking.
4. Wiggle test each circuit during the test to check for an intermittent open in the circuit.
NOTE: The test light should be illuminated and bright. Compare the brightness to that of a direct connection to the battery.
Is the test light illuminated and bright?
Yes
-
Test complete.
No
-
Repair the PCM Fused Ignition Switch circuit(s) for an open circuit or high resistance.
-
Perform the POWERTRAIN VERIFICATION TEST. See: Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/Verification Tests/Powertrain Verification Test
