PT Cruiser L4-2.4L Turbo (2009)
Ignition Cable: Service and Repair
Ignition Cable - Removal
REMOVAL
WARNING: Always turn the engine off and disconnect the battery prior to servicing the spark plug cables. Do not attempt to remove a spark
plug cable while the motor is running. Failure to follow these directions may result in serious or fatal injury.
1. Disconnect and isolate the negative battery cable.
NOTE: Always remove the spark plug cables by grasping the top of the spark plug insulator, turning the boot 1/2 turn and pulling straight up
in a steady motion.
2. Remove the spark plug cable from the ignition coil.
3. Remove the spark plug cable from the spark plug.
