PT Cruiser L4-2.4L Turbo (2009)
Engine Control Module: Procedures
Flash Programming
FLASH PROGRAMMING
NOTE: The wiTECH diagnostic application is the preferred method for flashing ECUs.
NOTE: Help using the wiTECH diagnostic application for flashing an ECU is available by selecting "Help" then "Help Contents" at the top
of the wiTECH diagnostic application window.
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
NOTE: The StarMobile Desktop Client may also be used to perform this flash procedure.
PCM/TCM Reprogramming
PCM / TCM PROGRAMMING
PCM / TCM FLASH PROGRAMING
This procedure will need to be done when one or more of the following situations are true:
1. A vehicle's Powertrain Control Module (PCM) has been replaced.
2. A diagnostic trouble code (DTC) is set P1602 - PCM Not Programmed.
3. An updated calibration or software release is available for either the PCM or TCM ECUs.
This procedure assumes that the wiTECH(TM) Vehicle Connection Interface (VCI) pod, StarSCAN(R) and StarMOBILE(R) devices are configured to
your dealership's network with either a wired or wireless connection. The wiTECH(TM) VCI pod, StarSCAN(R) and StarMOBILE(R) must also be
running at the latest operating system and software release level. For more help on how to network your StarSCAN(R) or StarMOBILE(R) reference the
StarSCAN(R) / StarMOBILE(R) Quick Start Networking Guide available on 'DealerCONNECT > Service > StarSCAN(R) and StarMOBILE(R) Tools
> Online Documentation, under the Download Center. For the wiTECH(TM) VCI pod use the "HELP" tab in the wiTECH(TM) Diagnostic Application.
Table of contents
1. SECTION 1 - PCM / TCM FLASH PROCEDURE
2. REQUIRED TOOLS/EQUIPMENT REQUIRED TOOLS/EQUIPMENT:
3. TECH TIPS and INFORMATION TECH TIPS and INFORMATION:
4. PARTS REQUIRED PARTS REQUIRED
SECTION 1 - PCM / TCM FLASH PROCEDURE
If using StarSCAN(R) or StarMOBILE(R) Desktop Client. Go To REPAIR PROCEDURE - Using StarSCAN(R) or StarMOBILE(R) Desktop
Client
If using wiTECH(TM) Diagnostic Application. Go To REPAIR PROCEDURE - wiTECH(TM) Diagnostic Application
REPAIR PROCEDURE - Using StarSCAN(R) or StarMOBILE(R) Desktop Client
NOTE: If this flash process is interrupted or aborted, the flash should be restarted.
1. Open the hood of the vehicle and install a battery charger. Verify that the charging rate provides a continuous charge of 13.2 - 13.5 volts.
2. Connect the StarSCAN(R) or StarMOBILE(R) to the vehicle data link connector located under the steering column and turn the ignition key to the
"RUN" position.
3. Power on the StarSCAN(R) or StarMOBILE(R). If the StarMOBILE(R) is being used, launch the StarMOBILE(R) Desktop Client and connect to
the appropriate StarMOBILE(R) device.
4. Retrieve the old ECU part number. From the tool's Home screen,
a. Select "ECU View"
b. Select "PCM/ECM"
c. Select "More Options"
d. Select "ECU Flash"
e. Record the part number at the top of the Flash PCM/ECM screen for later reference.
5. Program the ECU as follows:
a. Using the StarSCAN(R) / StarMOBILE(R) at the Home screen, select "ECU View"