PT Cruiser L4-2.4L Turbo (2009)
4. Reach up through the instrument panel access hole (1) and fasten the upper hook and loop retainers for the knee blocker airbag trim cover (4).
5. Install the two trim cover screws (3), one on each side of the column.
6. Connect the power mirror (if equipped) electrical connector and then place the instrument panel end cap into position and firmly snap into place.
7. Install the one end cap retaining screw.
8. Tuck the bottom of the under steering column cover into the top of the knee blocker airbag trim cover and then hook the hook and loop fasteners
(1 and 2) and snap the outer edges into place.
WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE
SYSTEM TEST IS NOT PERFORMED FIRST. FOR THE SYSTEM TEST, See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Supplemental Restraints
Verification Test
Passenger Air Bag - Removal
REMOVAL
NON-DEPLOYED AIRBAG
1. Open hood.
2. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service.
Failure to do so may result in accidental airbag deployment, serious or fatal injury.
