PT Cruiser L4-2.4L Turbo (2009)
1. Open hood.
2. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service.
Failure to do so may result in accidental airbag deployment, serious or fatal injury.
3. Roll/fold airbag towards instrument panel.
4. Close door over folded airbag and tape door closed.
5. Remove instrument panel top cover See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument
Panel Cover - Removal.
6. Open glove box, push in on the box/bin sides and lower to floor.
7. Remove the right instrument panel end cap.
8. Remove four passenger airbag cover screws along the bottom end of the airbag cover.
9. Remove two passenger airbag cover screws along the top edge of the airbag cover.
10. Remove two nuts retaining passenger airbag to instrument panel assembly inside glove box opening.
11. Lift airbag up until the wire connector is visible and disconnect the wire connector (1) from airbag (2). Unlock the locking tab and release the
connector.
12. Remove passenger airbag (2) from vehicle.
Passenger Air Bag - Installation
INSTALLATION
