PT Cruiser L4-2.4L Turbo (2009)
Seat Heater Switch: Service and Repair
Heated Seat Switch - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
NOTE: The heated seat switches are integral to the accessory switch bezel and cannot be serviced separately.
1. Disconnect and isolate the negative battery cable.
2. Remove the center bezel from the instrument panel and place it on a work bench See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Instrument Panel Bezel - Removal.
3. Remove the two screws (1) that secure the accessory switch bezel (2) to the back of the center bezel (3) and remove the switch bezel.
