PT Cruiser L4-2.4L Turbo (2009)
4. Install new stop lamp switch.
5. Connect brake booster rod to brake pedal. Install retainer clip (1).
6. Loosen adjustment screw (1) on clutch master cylinder pushrod. Gently lift clutch pedal upwards. Raising pedal with excessive force can
damage the pedal upstop, causing excessive pedal travel.
NOTE: Inspect plastic retainer upon removal. If retainer is damaged in any way (broken/cracked), it MUST be replaced.
7. Connect clutch master cylinder pushrod to pedal pin and torque adjustment screw to 6 Nm (55 in. lbs.).
8. Connect interlock/upstop and stop lamp switch connectors.
