PT Cruiser L4-2.4L Turbo (2009)
Power Steering Fluid: Service and Repair
POWER STEERING FLUID LEVEL CHECKING
WARNING: Fluid level should be checked with the engine OFF to prevent personal injury from moving parts and to assure an accurate fluid
level reading.
CAUTION: Mopar(R) Power Steering Fluid + 4 or Mopar(R) ATF+4 Automatic Transmission Fluid is to be used in the power steering system.
Both Fluids have the same material standard specifications (MS-9602). No other power steering or automatic transmission fluid is
to be used in the system. Damage may result to the power steering pump and system if another fluid is used. Do not overfill the
system.
NOTE: Although not required at specific intervals, the fluid level may be checked periodically. Check the fluid level anytime there is a system
noise or fluid leak suspected.
2.2L DIESEL ENGINE
The power steering fluid level can be viewed through the side of the power steering fluid reservoir. Compare the fluid level to the markings on the side of
the reservoir. When the fluid is at normal ambient temperature, approximately 21°C to 27°C (70°F to 80°F), the fluid level should read between the
MAX. COLD and MIN. COLD markings. When the fluid is hot, fluid level is allowed to read up to the highest end of the MAX. HOT range.
2.4L ENGINE
The power steering fluid level can be viewed on the dipstick attached to the filler cap. There are two ranges listed on the dipstick, COLD and HOT.
Before opening power steering system, wipe the reservoir filler cap free of dirt and debris. Remove the cap and check the fluid level on the dipstick.
When the fluid is at normal ambient temperature, approximately 21°C to 27°C (70°F to 80°F), the fluid level should read between the minimum and
maximum area of the COLD range. When the fluid is hot, fluid level is allowed to read up to the highest end of the HOT range.
2.4L TURBO ENGINE
The power steering fluid level can be viewed on the dipstick attached to the filler cap. Before opening power steering system, wipe the reservoir filler
cap free of dirt and debris. Remove the cap and check the fluid level on the dipstick. When the fluid is at normal ambient temperature, approximately 21°
C to 27°C (70°F to 80°F), the fluid level should read between the FULL and ADD markings.
