PT Cruiser L4-2.4L Turbo (2009)
5. Position a hose clamp onto end of the return hose (from steering gear) (2) far enough to clear the fitting on the internal cooler located within the
radiator portion of the cooling module (1).
6. Slide the return hose (2) onto the internal cooler fitting. Install the hose clamp on the hose past the bead formed into the end of the fitting and
secure in place.
7. Position a hose clamp (4) onto the end of the return hose (at steering gear) far enough to clear the tube in the steering gear (1) outlet port once
installed.
8. Slide the return hose onto the tube extending from the power steering gear (1) outlet port. Install the hose clamp (4) on the hose past the bead
formed into the end of the tube and secure in place.
9. Insert the end of the pressure hose into the inlet port on the power steering gear (1). Thread the pressure hose tube nut (3) into the inlet port, but
DO NOT TIGHTEN AT THIS TIME.
10. Install the routing clip (2) up from the gear outlet tube onto the fluid pressure hose tube.
11. While making sure fluid pressure hose stays in the routing clip (4), parallel with the return hose, tighten the pressure hose tube nut (3) at the gear
to 31 Nm (23 ft. lbs.).
12. lower the vehicle
