PT Cruiser L4-2.4L Turbo (2009)
13. Insert the end of the pressure hose into the pressure port on the power steering pump (6). Thread the pressure hose tube nut (5) into the power
steering pump pressure port. DO NOT TIGHTEN AT THIS TIME.
14. Install the mounting bolt through the routing bracket, attaching the pressure hose (2) to the front of the engine. Tighten the mounting bolt to 8 Nm
(70 in. lbs.).
15. Tighten the pressure hose tube nut (5) at the pump to 31 Nm (23 ft. lbs.).
16. Position the radiator fan on the cooling module and install the two upper and two side mounting screws (1). Tighten the screws to 6 Nm (55 in.
lbs.).
17. Position the cooling module back into its lower mounts.
