PT Cruiser L4-2.4L Turbo (2009)
3. Swing the axle trailing arms up aligning the brackets (3) with the scribed marks made upon removal.
4. Install all eight (four per side) axle bracket-to-body mounting bolts (4). Thread the bolts in, but do not fully tighten at this time.
5. Tap the brackets (3) as necessary to align the brackets with the scribed marks, then tighten all the bolts to 54 Nm (40 ft. lbs.).
6. Install a rubber isolator on each end of the coil springs wrapping the rubber fingers around the coil (2). Turn each isolator until the rubber
abutment (1) butts up against the flat end of the spring coil.
NOTE: Both ends of the coil spring are identical. Either end of the spring can be the top or bottom.
