PT Cruiser L4-2.4L Turbo (2009)
33. Install the rear parking brake cables (3) into the equalizer (2) on the parking brake lever output cable (1).
WARNING: The automatic adjusting feature of this parking brake lever contains a clockspring loaded to approximately 19 pounds. Do not
release the automatic adjuster lockout device unless the rear parking brake cables and equalizer are connected to the lever output
cable. Keep hands out of automatic adjuster sector and pawl area. Failure to observe caution in handling this mechanism could
lead to serious injury.
NOTE: The parking brake lever can only be in the released position when releasing the automatic adjuster.
34. Ensure that the parking brake cables are correctly installed on the equalizer and aligned with the cable track on the parking brake lever (1).
35. Keeping hands clear of the automatic adjuster sector and pawl area, firmly grasp the pin punch (3) (drill bit or locking pin) installed in the parking
brake lever (1), then quickly remove it from the lever mechanism. This will allow the parking brake lever mechanism to automatically adjust the
parking brake cables.
36. Cycle the parking brake lever once to position the parking brake cables, then return the parking brake lever its released position.
37. Check the rear wheels of the vehicle. They should rotate freely without excessive dragging with the lever in the released position.
38. Lower the vehicle.
