PT Cruiser L4-2.4L Turbo (2009)
8. Remove the three bolts (2) mounting the bearing retainer plate (3) to the knuckle. Remove the bearing retainer plate from the knuckle.
9. Place the knuckle back in the arbor press face down as shown. The press support blocks must not obstruct the bearing while it is being pressed out
of the steering knuckle.
10. Place Remover/Installer (2), Special Tool MB-990799, on the outer race of the wheel bearing. Lower the arbor press ram (1) and remove the
wheel bearing from the knuckle.
11. If the bearing race is still pressed onto the hub, install the Bearing Splitter (3), Special Tool 1130, between the hub flange and the bearing race (5).
12. Place the hub, bearing race and bearing splitter in an arbor press as shown. The press support blocks (4) must not obstruct the wheel hub while it is
being pressed out of the bearing race.
13. Place Remover/Installer (6), Special Tool 6644-2, on end of hub (2). Lower the arbor press ram (1) and remove the hub from the bearing race.
NOTE: For steering knuckle reassembly, See: Assembly .
