PT Cruiser L4-2.4L Turbo (2009)
1. Install transmission oil cooler and tighten screws to 8 Nm (70 in. lbs.).
NOTE: When the transaxle cooler lines are removed from the rolled-groove type fittings at the cooler and transaxle, damage to the inner wall
of hose will occur. To prevent potential leakage, the cooler hoses and clamps must be replaced.
2. Replace automatic transmission cooler hoses (3) and clamps.
3. Connect hoses (3) to cooler (2).
4. Install front fascia. See: Body and Frame/Bumper/Front Bumper/Front Bumper Cover / Fascia/Service and Repair/Front Bumper Fascia -
Installation
5. Start engine and check transmission fluid level. Adjust level as necessary.
Turbo
