PT Cruiser L4-2.4L Turbo (2009)
NOTE: When the transaxle cooler lines are removed from the rolled-groove type fittings at the cooler and transaxle, damage to the inner wall
of hose will occur. To prevent potential leakage, the cooler hoses and clamps must be replaced.
1. Replace automatic transmission cooler hoses and clamps.
2. Connect lines to cooler
3. Install transmission oil cooler (1) and tighten screws (2) to 8 Nm (70 in. lbs.).
4. Install radiator closure panel center brace (2).
5. Install upper radiator closure panel (1).See: Body and Frame/Radiator Support/Service and Repair/Radiator Upper Crossmember - Installation
6. Install grille See: Body and Frame/Grille/Service and Repair/Grille - Installation.
7. Start engine and check transmission fluid level. Adjust level as necessary.
