PT Cruiser L4-2.4L Turbo (2009)
12. With the aid of a helper, position the windshield over the windshield opening and install encapsulation locator pin then load encapsulation hooks
onto the roof panel hooks (3).
13. Push windshield into opening until no gap encapsulation lays evenly along roof panel and there is no gapping of encapsulation squeak tape to the
windshield opening
14. Clean excess urethane (4) from exterior with Mopar, Super clean or equivalent.
15. Apply tape to windshield assembly as required if gap exists around windshield opening.
16. After urethane has cured, remove tape strips and water test windshield to verify repair.
17. Install cowl covers.
18. Install inside rear view mirror.
19. Allow urethane to cured for 10-12 hours. Remove tape strips and water test windshield.
