PT Cruiser L4-2.4L Turbo VIN G (2004)
Antenna Cable: Service and Repair
Antenna Body & Cable
ANTENNA BODY AND CABLE
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove antenna mast by unscrewing mast from antenna body. On vehicles equipped with manual retractable antenna, lower antenna fully.
3. Remove shroud (if equipped).
Fig. 2 Antenna Body And Cable
4. Remove antenna nut and adapter.
5. Disconnect antenna body cable from instrument panel antenna cable.
6. Remove inner fender shield as necessary to gain access to mounting fasteners.
Fig. 3 Antenna Mounting
7. Remove mounting fasteners and remove antenna body and cable assembly from fender (Fig.3).
INSTALLATION
1. Position antenna body and cable assembly into fender. Tighten mounting screws to 7 Nm (75 in. lbs.)
2. Insert antenna cable through the opening in fender.
3. Seat the grommet in the side panel and connect the cable to the instrument panel harness connector.
4. Install antenna nut and adapter.
