PT Cruiser L4-2.4L Turbo VIN G (2004)
Trunk / Liftgate Striker: Service and Repair
Liftgate
STRIKER
REMOVAL
1. Open the liftgate.
2. Remove the liftgate sill scuff plate. Refer to Trim Panel.
NOTE: Place a reference mark along the outer edge of the striker to ensure it is reinstalled to its original position.
3. Mark the position of the striker (1) on the liftgate opening lower panel (3) to aid installation.
4. Remove the two screws (2) that secure the striker to the lower panel and remove the striker.
INSTALLATION
1. Position the liftgate striker (1) onto the liftgate opening lower panel (3) and align the striker to the previously marked location.
2. Install the two bolts (1) that secure the striker to the lower panel. Tighten the bolts to 28 N.m (21 ft. lbs.).
3. Verify liftgate alignment and latch operation. The liftgate should fit flush and have even gaps to adjacent body panels. Gap specifications are as
follows:
-
7 mm (0.280 in.) to the fascia.
-
6 mm (0.240 in.) to the roof header.
-
4 mm (0.160 in.) to the body side.
4. Install the liftgate sill scuff plate.
