PT Cruiser L4-2.4L Turbo VIN G (2004)
Sunroof / Moonroof Panel: Procedures
Sunroof Glass Panel
GLASS PANEL
REMOVAL
1. Move the glass panel to the closed position.
2. Slide sunshade rearward to the open position.
Fig. 6 Glass Panel
3. Remove the four glass panel screws.
4. Lift off glass panel and remove from vehicle.
INSTALLATION
1. Position glass panel on to mechanism lift arms.
2. Start the four attaching screws, do not fully tighten.
3. Adjust sunroof glass (Refer to BODY/SUNROOF/GLASS PANEL - ADJUSTMENTS).
4. Verify sunroof operation and alignment.
Sunroof Glass Panel Seal
SUNROOF GLASS PANEL SEAL
REMOVAL
1. Remove sunroof glass panel (Refer to BODY/SUNROOF/GLASS PANEL - REMOVAL).
2. Place glass panel on a clean work area with the top side up. Support the glass assembly from under side to avoid bending or otherwise damaging
the mounting tabs.
3. Grasp the seal and pull seal away from the glass panel. The seal is a one piece seal.
INSTALLATION
NOTE: Always position seal seam on center side of the passenger side of glass panel.
1. Place seal into position.
2. Install seal on glass panel. Using care working the seal around the glass, being careful not to stretch the seal while installing.
3. Replace sunroof glass panel (Refer to BODY/SUNROOF/GLASS PANEL - INSTALLATION).
4. Verify sunroof operation and alignment (Refer to BODY/SUNROOF/GLASS PANEL - ADJUSTMENTS).
