PT Cruiser L4-2.4L Turbo VIN G (2004)
11. Mount and adjust the NEW brake lamp switch using the following procedure:
-
Install the switch in its bracket by aligning the index tab on the switch with the slot in the mounting bracket.
-
When the switch is fully seated in its bracket, rotate the switch clockwise approximately 30° to lock the switch into place.
-
With the brake pedal in the fully released position, move the lever on the back of the brake lamp switch from the non-adjusted angle position
to the full vertical position. This will adjust the brake lamp switch to the vehicle.
12. Install the knee blocker.
13. Install the silencer pad below the knee blocker.
14. Reconnect the battery negative terminal.
15. Reinstall the air cleaner cover (two clips).
16. Check the stop lamps to verify they are operating properly and not staying on when the pedal is in the released position.
17. Road test the vehicle to ensure proper operation of the brakes and speed control (if equipped).
