PT Cruiser L4-2.4L Turbo VIN G (2004)
6. Carefully apply upward force, allowing the upper engine to rotate rearward until the distance between the center of the rearmost attaching bolt on
the engine mount bracket (point "A") and the center of the hole on the shock tower bracket (point "B") is 119 mm (4.70 inch) (Fig. 96).
CAUTION: The engine must be held in position with jack until both the upper and lower torque strut bolts are tightened.
7. With the engine held at the proper position, tighten both the upper and lower torque strut bolts to 115 Nm (85 ft. lbs.) (Fig. 92).
8. Remove the floor jack.
9. Install pencil strut and tighten nuts to 58 Nm (43 ft. lbs.) (Fig. 94).
10. Install accessory drive belt splash shield (Fig. 93).
