PT Cruiser L4-2.4L Turbo VIN G (2004)
3. Rotate the hub so the stud mounting holes in the hub are facing in the direction shown in the figure.
4. Install the Bearing Splitter, Special Tool 1130, between the hub and the bearing retainer plate as shown. Absence of the three wheel mounting
studs allows the bearing splitter to be installed behind the flange. Hand tighten the nuts to hold bearing splitter in place on steering knuckle.
5. Place the steering knuckle face down in an arbor press supported by the bearing splitter as shown.
6. Position Remover/Installer, Special Tool 6644-2, on the small end of the hub. Using the arbor press, remove the hub from the wheel bearing. The
bearing race will normally come out of the wheel bearing with the hub as it is pressed out of the bearing.
7. Remove the bearing splitter from the steering knuckle.