PT Cruiser L4-2.4L Turbo VIN G (2004)
a. Remove the disc brake caliper guide pin bolts, then the caliper from the disc brake adapter.
b. Hang the caliper out of the way using a wire hanger or bungee cord.
c. Remove the brake rotor retaining clips.
d. Remove the brake rotor from the rear hub and bearing.
5. Remove the dust cap from the hub and bearing.
6. Remove the hub and bearing retaining nut from the spindle, then remove the hub and bearing.
INSTALLATION
1. Install the hub and bearing on the spindle. Install a NEW hub and bearing retaining nut. Tighten the retaining nuts to a torque of 217 Nm (160 ft.
lbs.).
2. Install the hub and bearing dust caps.
3. On drum brake equipped vehicles, install the brake drum.
4. On vehicles equipped with rear disc brakes:
a. Install the brake rotor.
b. Install the disc brake caliper.
c. Install the caliper guide pin bolts, then tighten them to a torque of 22 Nm (192 inch lbs.).
5. Install the rear tire and wheel assembly. Tighten all wheel nuts to a torque of 135 Nm (100 ft. lbs.).
6. Lower the vehicle.
