PT Cruiser L4-2.4L Turbo VIN G (2004)
Fig. 58 Throttle Body - 2.4L Turbo
12. Remove the throttle body (Fig. 58).
Fig. 59 Throttle Body Gasket- 2.4L Turbo
13. Clean and replace gasket (Fig. 59).
INSTALLATION - 2.4L TURBO
1. Clean and replace gasket (Fig. 59).
2. Install the throttle body (Fig. 58).
3. Install the 3 bolts to the throttle body and tighten to 11.8 ± 20 Nm (105 in. lbs.) (Fig. 57).
4. Connect the purge hose to the throttle body
5. Connect the throttle body inlet hose to the throttle body and tighten clamp.
6. Install bracket (Fig. 56).
7. Install the 2 screws for the throttle cable bracket and tighten to 11.8 ± 20 Nm (105 in. lbs.).
8. If equipped with speed control, install speed control cable to the throttle lever by sliding clasp in the hole used for throttle cable.
9. Install the throttle cable to the throttle body lever (Fig. 55).
10. Install the throttle control shield (Fig. 54).
11. Connect and lock the electrical connectors from the idle air control motor and throttle position sensor.
12. Connect and lock the electrical connector for the inlet air temperature sensor.
13. Connect the negative battery cable
