PT Cruiser L4-2.4L Turbo VIN G (2004)
Seat Heater Control Module: Testing and Inspection
Refer to the appropriate wiring information in Wiring Diagrams. The wiring information includes wiring diagrams, proper wire and connector repair
procedures, further details on wire harness routing and retention, as well as pin-out and location views for the various wire harness connectors, splices
and grounds.
1. If a heated seat fails to heat and one or both of the LED indicator lamps on a heated seat switch flash, refer to Heated Seat System Diagnosis and
Testing.
2. Test the appropriate Heated Seat Switch, refer to the procedure in the Heated Seats.
3. Test the Heated Seat Sensor, refer to the procedure in the Heated Seats.
4. Test the Heated Seat Element, refer to the procedure in the Heated Seats.
5. Disconnect the heated seat module connector receptacle. Using an ohmmeter, check for continuity between the ground circuit cavity and a good
ground. If OK, go to Step 6. If not OK, repair the open ground circuit to ground as required.
6. Disconnect the heated seat module connector receptacle. Using an voltmeter, check for voltage on the B+ circuit cavity. If OK, go to Step 7. If not
OK, repair the open B+ circuit as required.
7. Replace the heated seat module with a known good module. Test operation of the heated seat system. If system works, OK repair complete. If
system is still inoperative a short or open exists in the heated seat system wiring. Using Wiring Diagrams as a guide, check the individual circuits
until the short or open is found.