PT Cruiser L4-2.4L Turbo VIN G (2004)
Seat Heater Control Module: Service and Repair
WARNING: THERE ARE MANY SHARP METAL EDGES ON THE SEAT CUSHION FRAME AND SEAT ADJUSTER RAILS UNDER
THE SEAT. WHEN PERFORMING THIS SERVICE, A LONG-SLEEVED SHIRT AND GLOVES SHOULD BE WORN IN ORDER TO
AVOID UNNECESSARY CUTS AND ABRASIONS TO EXPOSED SKIN.
1. Move the driver power seat to its full up and full rear stop positions.
2. Disconnect and isolate the battery negative cable.
Heated Seat Module Location - Typical
3. Working under the seat, release the two plastic push-in fasteners from either the module or the mounting holes in the power seat cushion pan.
4. Disconnect the power seat wire harness connector from the heated seat module connector receptacle.
5. Remove the heated seat module from the power seat track.
INSTALLATION
1. If the two plastic push-in fasteners for the heated seat module were damaged during removal, install new fasteners onto the heated seat module.
2. Reconnect the power seat wire harness connector to the heated seat module connector receptacle. Be certain that the cavities in the power seat wire
harness connector are aligned with the terminals in the heated seat module connector receptacle before pushing the connector firmly into place.
3. Install the heated seat module on the power seat cushion pan.
4. Reconnect the battery negative cable.
