PT Cruiser L4-2.4L Turbo VIN G (2004)
Fig. 14 Front Wiper Module - RHD - Remove/Install
8. Remove three front wiper module mounting bolts and remove module from vehicle.
NOTE:
-
If replacing the front wiper module, the wiper motor must be transferred to the new module.
-
Remove the one bell crank retaining nut and remove bell crank.
-
Remove three bolts to the front wiper motor and separate from module.
INSTALLATION
NOTE:
-
If the front wiper module was replaced, install the wiper motor on the new module.
-
Place the motor on the wiper module and install the three bolts to the front wiper motor.
-
Install the bell crank and one bell crank retaining nut.
Fig.13 Front Windshield Wiper Module Remove/Install
1. Place the front wiper module into cowl area and install the three mounting bolts. Torque the mounting screws to 8 Nm (75 in. lbs.).
2. Connect the front wiper motor posi-lock harness connector.
3. Install the cowl cover. The right side cover overlaps the left side cover.
a. Place the left side cowl cover into position and install the two push retainers.
b. Place the right side cowl cover into position and install the two push retainers.
c. Install the rear engine compartment seal at the cowl.
