PT Cruiser L4-2.4L Turbo VIN G (2004)
Air Bag: Service and Repair
Passenger Airbag
REMOVAL
Non-Deployed Airbag
1. Open hood.
2. Disconnect and isolate the battery negative cable. Wait two minutes for the capacitor to discharge.
3. Remove instrument panel top cover.
4. Open glove box, push in on the box/bin sides and lower to floor.
5. Remove the right instrument panel end cap.
6. Remove four passenger airbag cover screws along the bottom end of the airbag cover.
7. Remove two passenger airbag cover screws along the top edge of the airbag cover.
Fig. 19 Passenger Airbag Retaining Nuts
8. Remove two nuts retaining passenger airbag to instrument panel assembly inside glove box opening.
Fig. 20 Passenger Airbag Electrical Connector
9. Lift airbag up until the wire connector is visible and disconnect the 4-way wire connector from airbag. Unlock the red locking tab and compress
lock to release the connector.
10. Remove passenger airbag from vehicle.
