PT Cruiser L4-2.4L Turbo VIN G (2004)
Deployed Airbag
1. Open hood.
2. Disconnect and isolate the battery negative cable.
3. Roll/fold airbag towards instrument panel.
4. Close door over folded airbag and tape door closed.
5. Remove instrument panel top cover.
6. Open glove box, push in on the box/bin sides and lower to floor.
7. Remove the right instrument panel end cap.
8. Remove four passenger airbag cover screws along the bottom end of the airbag cover.
9. Remove two passenger airbag cover screws along the top edge of the airbag cover.
10. Remove two nuts retaining passenger airbag to instrument panel assembly inside glove box opening.
11. Lift airbag up until the wire connector is visible and disconnect the 4-way wire connector from module. Unlock the red locking tab and compress
lock to release the connector.
12. Remove passenger airbag from vehicle.
INSTALLATION
1. Place airbag into instrument panel opening, connect the 4-way wire connector, and lock the red locking tab.
2. Install the two nuts retaining passenger airbag to instrument panel assembly inside glove box opening. Torque the two airbag retaining nuts to 22
to 34 Nm (200 to 300 in. lbs.) torque.
3. Install two passenger airbag cover screws along the top edge of the airbag cover. Torque trim screws to 2 Nm (20 in. lbs.).
4. Install four passenger airbag cover screws along the bottom end of the airbag cover. Torque trim screws to 2 Nm (20 in. lbs.).
5. Install the right instrument panel end cap.
6. Push in on the box/bin sides and close glove box door.
7. Install instrument panel top cover.
WARNING: DO NOT CONNECT BATTERY NEGATIVE CABLE YET (Refer to ELECTRICAL/RESTRAINTS - DIAGNOSIS AND
TESTING - AIRBAG SYSTEM).
8. Close hood.
9. Verify vehicle and system operation.
