PT Cruiser L4-2.4L Turbo VIN G (2004)
Fig. 27 Side Airbag Impact Control Module Connector
8. Disconnect the SIACM electrical connector.
9. Remove the SIACM from the vehicle.
INSTALLATION
The installation of the driver and passenger side modules is identical. The orientation of the modules is the only difference (which way they are tilted).
WARNING: THE MODULES CANNOT BE INTERCHANGED. THEY ARE UNIQUE TO EACH SIDE.
1. Connect the SIACM electrical connector.
NOTE: Place the ground eyelet over the TOP REAR (towards the rear of the vehicle) weld stud when reattaching the SIACM. This location
prevents the eyelet from spinning during tightening.
2. Position the SIACM in the b-pillar, replace ground eyelet, and install the retaining nuts. Torque the nuts to 20 Nm (175 ± 25 in. lbs.).
3. Install the seat belt retractor (Refer to ELECTRICAL/RESTRAINTS/FRONT SEAT BELT & RETRACTOR - INSTALLATION).
4. Install the lower B-pillar trim.
5. Connect the harness side of the connector. Install the lower seat trim.
WARNING: DO NOT CONNECT BATTERY NEGATIVE CABLE YET (Refer to ELECTRICAL/RESTRAINTS - DIAGNOSIS AND
TESTING - AIRBAG SYSTEM).
6. Close hood.
7. Verify vehicle and system operation.
