PT Cruiser L4-2.4L Turbo VIN G (2004)
6. Install the four bolts fastening the A/C compressor to the engine. Tighten the mounting bolts to a torque of 28 Nm (250 inch lbs.).
7. Install the A/C compressor electrical connectors.
8. Install the A/C drive belt.
9. Install the drive-belt splash shield and fasteners.
10. Install the screws fastening the front fascia to the reinforcement.
11. Install the right front tire and wheel assembly. Install and tighten the wheel mounting nuts to a torque of 135 Nm (100 ft. lbs.).
12. Tighten the mounting bolt securing the pressure hose and routing bracket to the front of the engine to a torque of 61 Nm (45 ft. lbs.).
13. Attach the pressure hose and routing brackets to the structural collar. Tighten the mounting bolts to a torque of 61 Nm (45 ft. lbs.).
14. Using a lint free towel, wipe clean the open power steering hose end and the power steering gear port. Replace any used O-rings with new.
Lubricate the O-ring with power steering fluid.
CAUTION: Forward of the steering gear, the power steering fluid pressure hose routes between the front suspension crossmember and the
driveshaft. When tightening the pressure hose tube nut to the steering gear, the pressure hose must be positioned (clocked) such that its final
routing (after tightened to 47 Nm (35 ft. lbs.)) offers 4-10 mm clearance to the front suspension crossmember (measured at the pressure hose
steel-to-rubber coupling).
15. Attach the power steering fluid pressure hose to its port on the power steering gear. While making sure the hose is not in contact with any vehicle
components (see preceding caution), tighten the pressure hose tube nut at the gear to a torque of 47 Nm (35 ft. lbs.).
16. Lower the vehicle.
17. Perform the POWER STEERING PUMP INITIAL OPERATION procedure.
18. Check for leaks at all hose connections.
