PT Cruiser L4-2.4L Turbo VIN G (2004)
2. Install the power steering supply hose into the engine compartment. First, route the pump end of the hose down to the pump supply fitting, then
place the reservoir end of the hose onto the fitting of the power steering fluid reservoir.
3. Expand the hose clamp at the fluid reservoir and slide it over the hose and fitting. Secure the clamp once it is past the bead formed into the fluid
reservoir fitting.
4. Expand the remaining hose clamp and slide it over the hose and pump supply fitting. Secure the clamp once it is past the bead formed into the fluid
reservoir fitting.
CAUTION: Make sure the hose routing is above the engine timing chain cover. The power steering fluid supply hose must remain clear of any
unfriendly surface that can cause possible damage to it.
5. Install the radiator closure panel and fasten it in place.
6. Install the ambient temperature sensor on the radiator closure panel.
7. Install the hood-opening weather-strip across the radiator closure panel.
8. Install the grille on the front of the vehicle.
9. Perform the POWER STEERING PUMP INITIAL OPERATION procedure.
10. Check for leaks at all hose connections.
