PT Cruiser L4-2.4L Turbo VIN G (2004)
Power Steering Pump: Testing and Inspection
PUMP INITIAL OPERATION
WARNING: THE FLUID LEVEL SHOULD BE CHECKED AND ADJUSTED WITH THE ENGINE OFF TO PREVENT INJURY FROM
MOVING ENGINE COMPONENTS.
CAUTION: Use only Mopar ATF+4 Automatic Transmission Fluid (MS-9602). Do not overfill.
The fluid level should read between the minimum and maximum area of the COLD range when the fluid is at normal temperature, approximately 21°C
to 27°C (70°F to 80°F).
1. Fill the power steering fluid reservoir to the proper level and let the fluid settle for at least two minutes.
2. Start the engine and let run for a few seconds, then turn the engine off.
3. Add fluid if necessary. Repeat the above procedure until the fluid level remains constant after running the engine.
4. Raise the front wheels off the ground.
5. Start the engine. Slowly turn the steering wheel right and left, lightly contacting the wheel stops.
6. Add power steering fluid if necessary.
7. Lower the vehicle and turn the steering wheel slowly from lock to lock.
8. Stop the engine. Check the fluid level and refill as required.
9. If the fluid is extremely foamy, allow the vehicle to stand a few minutes and repeat the above procedure.
