PT Cruiser L4-2.4L Turbo VIN G (2004)
NOTE:
If the installed dimension is less than 12 mm a binding condition may result. If the installed dimension is greater than 14 mm a loose condition
may result.
25.
Verify the click sound has been corrected. If a sound is still present further diagnosis is required.
26.
Using the procedures outlined in the appropriate service information, install the steering column assembly into the vehicle.
27.
PT VEHICLES - If the airbag retainer clips or foam silencer pads are damaged, they must be replaced.
a.
Use a large flat tipped screwdriver to pry up on the middle of the driver air bag retaining clip to remove it from the steering wheel armature
holes. Refer to (Fig. 5)
b.
Use a small screwdriver to remove the three (3) existing foam pads from the steering wheel base.
c.
Insert new clip(s), p/n 05086385AA, in the steering wheel armature holes. The round end of the clip goes in the small hole, open end goes in
the larger hole. Put round end in first and press open end with screwdriver as shown in (Fig. 6).
d.
Install three (3) new foam pads, found in the kit. THE POSITIONING OF THE FOAM PADS IS CRITICAL, AS THE GROUND FOR
THE HORN IS AFFECTED BY POSITION OF THE PADS. Two EXTRA pads are included in the kit.
