PT Cruiser L4-2.4L Turbo VIN G (2004)
1. Install the strut assembly into the strut tower, aligning the three studs on the strut upper mount with the holes in strut tower. Install the three
mounting nuts on the stud. Tighten the three nuts to a torque of 34 Nm (25 ft. lbs.).
2. Close the hood of the vehicle.
CAUTION: The strut assembly-to-steering knuckle attaching bolts are serrated and must not be turned during installation. Install the nuts while holding
the bolts stationary in the steering knuckle.
3. Position the lower end of the strut assembly in line with the upper end of the steering knuckle and align the mounting holes. Install the two
attaching bolts. The bolts should be installed so that the nuts face towards the front of the vehicle once installed. Install the nuts. Holding the bolts
in place tighten the nuts to a torque of 53 Nm (40 ft. lbs.) plus an additional 90° turn after the specified torque is met.
4. If the vehicle is equipped with Antilock Brakes (ABS), attach the ABS wheel speed sensor to the rear of the strut (rearward ear) using its mounting
screw. Tighten the mounting screw to a torque of 13 Nm (120 inch lbs.).
5. Attach the ground strap to the rear of the strut (forward ear) using its mounting screw. Tighten the mounting screw to a torque of 13 Nm (120 inch
lbs.).
6. Install the tire and wheel assembly. Install and tighten the wheel mounting nuts in proper sequence until all nuts are torqued to half specification.
Next, repeat the tightening sequence to the full specified torque of 135 Nm (100 ft. lbs.).
7. Lower the vehicle.
