chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Windshield|Service Precautions|Page 8912 > < Windshield|Service Precautions|Page 8910
Page 5
background image

12. With the aid of a helper, position the windshield over the windshield opening and install encapsulation locator pin then load encapsulation hooks

onto the roof panel hooks (3).

13. Push windshield into opening until no gap encapsulation lays evenly along roof panel and there is no gapping of encapsulation squeak tape to the

windshield opening 14. Clean excess urethane (4) from exterior with Mopar, Super clean or equivalent.

15. Apply tape to windshield assembly as required if gap exists around windshield opening.
16. After urethane has cured, remove tape strips and water test windshield to verify repair.
17. Install cowl covers.
18. Install inside rear view mirror.
19. Allow urethane to cured for 10 - 12 hours. Remove tape strips and water test windshield.

CONVERTIBLE

CAUTION:  Open the left front door glass before installing windshield to avoid pressurizing the passenger compartment. If a door is slammed
before urethane bonding is cured, water leaks can result. Allow the urethane at least 24 hours to cure before returning the vehicle to use. To
avoid stressing the replacement windshield, the urethane bonding material on the windshield fence should be smooth and consistent to the
shape of the replacement windshield. The support spacers should be cleaned and properly installed on weld studs or repair screws at bottom of
windshield opening
.

1. Verify support spacers in windshield opening. If not present, install spacers as indicated.
2. Position windshield into opening by contacting header spacers then loading the glass hooks onto the panel hooks.
3. Verify glass encapsulation lays evenly along roof panel and that there is no gapping of the glass to spacers in the windshield opening. If gaps are

present, the pinch weld fence must be formed to the shape of the new glass.

4. Remove replacement windshield from opening.

5. Position the windshield inside up on a suitable work surface with two padded, wood 10 cm by 10 cm by 50 cm (4 in. by 4 in. by 20 in.) blocks,

placed parallel 75 cm (2.5 ft.) apart.

Windshield|Service Precautions|Page 8912 > < Windshield|Service Precautions|Page 8910