PT Cruiser L4-2.4L Turbo VIN G (2004)
1. Install new grommet into the reservoir.
2. Insert pump into pump grommet and firmly snap into reservoir.
3. Place reservoir into cowl area and connect the washer hoses.
NOTE: The hose with the white stripe goes on the white side of the pump and the black hose on the black side of the pump.
4. Connect the pump wire connector.
5. Install the three reservoir retaining screws. Torque screws to 8 Nm (70 in. lbs.).
6. Install the right cowl cover.
a. Place the right side cowl cover into position and install the two push retainers.
b. Install the rear engine compartment seal at the cowl.
Before installation of the front wiper arms, activate the wiper system to ensure the front wiper module is in the PARK position. Position wiper
arms so that the tip of the driver's blade and the middle of the passenger's blade is on the park line on the windshield (Refer to
ELECTRICAL/WIPERS/WASHERS/WIPER ARMS - ADJUSTMENTS).
7. Place the arm on the pivot while the arm is in an over/centered position.
8. Install the wiper arm retaining nut and torque to 21 Nm (190 in. lbs.).
9. Install the wiper arm nut cap.
10. Connect the battery negative cable.
11. Close hood.
12. Verify vehicle and system operation.
