PT Cruiser L4-2.4L Turbo VIN G (2004)
Windshield Washer Motor: Service and Repair
Washer Pump Motor Replacement - RHD
REMOVAL
1. Open hood.
Fig. 12 Battery Negative Cable - Remove/Install
2. Disconnect and isolate the battery negative cable.
Fig.9 Front Wiper Arm Remove/Install
3. Using a trim stick (special tool #C-4755) or equivalent, gently pry up on the wiper arm nut cap and remove.
4. Remove wiper arm retaining nut.
5. Remove the arm from the pivot using a rocking motion while the arm is in an over/centered position .
6. Remove the cowl cover. The right side cover overlaps the left side cover, so they both must be removed.
a. Remove the rear engine compartment seal at the cowl.
b. Remove the three push retainers to the right side cowl cover and remove from vehicle.
7. Remove three reservoir retaining screws.
8. Disconnect the pump wire connector.
9. Disconnect the washer hose connections.
10. Lift washer reservoir out of cowl area and drain into bucket.
11. Gently pry pump away from reservoir and out of grommet. Care must be taken not to puncture reservoir.
12. Remover rubber grommet from reservoir.
INSTALLATION
CAUTION: A new grommet must be used every time the pump is removed/installed from the reservoir to prevent possible leaks in the future.
1. Install new grommet into the reservoir.
