Sebring L4-122 2.0L DOHC VIN Y MFI (1995)
Installation Service Point
5. Set the knob for the air outlet changeover on the heater control assembly to the DEF position.
6. Set the air outlet changeover damper lever of the heater unit to DEF position and install the cable to the lever pin.
7. Push the outer cable in the direction of the arrow so that there is no looseness, and then secure it with the clip.
Installation Service Point
8. Set the lever for the inside/outside air changeover on the heater control assembly to the air-recirculation position.
9. Set the inside/outside air changeover damper lever of the blower unit to air-recirculation position (with the inside/ outside air changeover damper
lever touched to the stopper of the blower case) and install the cable to the lever pin.
10. Push the outer cable in the direction of the arrow so that there is no looseness, and then secure it with the clip.
NOTE: For the sliding section of heater control panel use MOPAR Multipurpose Grease Part No. 2932524 or equivalent -- As required.
