Sebring V6-2.5L SOHC 24 Valve (1996)
3.
Inspect the parts for damage. If any are broken, the pivot rod is missing or bent, or the spring is missing, refer to the parts required section for part
replacement information.
4.
Disassemble the lid from the holder by removing the pivot shaft. Take care not to lose the spring.
5.
Using a vise, crimp approximately 2 - 3 mm (5/64 - 7/64 inch) of one end of the pivot shaft.
NOTE:
DO NOT CRIMP ANY MORE OF THE SHAFT THAN SPECIFIED. IMPROPER OPERATION COULD OCCUR.
6.
Reassemble the lid and holder along with the pivot rod and spring as follows:
A.
Slide the pivot shaft into the lid hole (non crimped end first).
B.
Slide the pivot shaft through the first set of holder holes.
C.
Slide the pivot shaft through the second set of holder holes and through the spring. Make sure the spring is positioned correctly for proper
tension on the holder.
D.
Press the crimped end of the shaft into the lid hole. Make sure the shaft will not slide out.
7.
Reassemble the cup holder assembly into the console. Take care not to break any plastic pivots during reassembly.
8.
Check cupholder for proper operation.
POLICY: Reimbursable within the provisions of the warranty.
