Sebring V6-2.5L VIN N (1997)
Stabilizer Link: Service and Repair
Rear
NOTE: The only reason to replace the dust cover is if it is damaged by mistake during servicing, replace it as follows.
BALL JOINT DUST COVER REPLACEMENT
1. Remove the clip ring and the dust cover.
2. Apply Mopar (R) Multi-mileage Lubricant Part No. 2525035 or equivalent to the lip and inside of the dust cover.
3. Wrap plastic tape around the stabilizer link threads as shown in the illustration, and then install the dust cover to the stabilizer link.
4. install the clip ring to secure the dust cover.
NOTE: Align the ends of clip ring at a 90° angle from the axis of the stabilizer link.