Sebring Convertible L4-2.4L VIN X (2004)
Seat Heater Switch: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the center console. Refer to the Body section of this manual for the procedure.
3. Disconnect the center console wire harness connector from the connector receptacle on the back of the heated seat switch.
4. Remove the heated seat switch by depressing the retaining tabs and pushing straight out of the center console.
INSTALLATION
NOTE: Be certain to install the switch in the correct orientation, drivers switch on the left and passenger on the right.
1. Connect the center console wire harness connector on the connector receptacle on the back of the heated seat switch.
2. Verify switch/system operation.
3. Install the center console.
4. Install the heated seat switch in the center console mounting hole.
5. Reconnect the battery negative cable.
