Sebring Convertible L4-2.4L VIN X (2004)
Fuel Injector: Service and Repair
REMOVAL - 4 CYLINDER
Fig.12 Fuel Rail And Injectors
The fuel rail must be removed first (Fig. 12). Refer to Fuel Rail Removal.
Fig.13 Ful Injector And Rail - Typical
1. Position fuel rail assembly so that the fuel injectors are easily accessible (Fig. 13).
2. Remove injector clip and pull injector out of fuel rail.
3. Check injector O-ring for damage. If O-ring is damaged, it must be replaced. Replace the injector clip if it is damaged.
4. Repeat for remaining injectors.
INSTALLATION
INSTALLATION - 4 CYLINDER
1. Before installing an injector the rubber O-ring must be lubricated with a drop of clean engine oil to aid in installation.
2. Install injector clip by sliding open end into the top slot of the injector. The edge of the receiver cup will slide into the side slots of clip.
