Sebring Convertible L4-2.4L VIN X (2004)
Sunroof / Moonroof Module: Service and Repair
Sunroof Module Assembly
REMOVAL
1. Move glass panel to the fully closed position.
2. Disconnect battery negative cable.
3. Recline both front seats.
4. Remove sunroof opening trim lace. (Refer to BODY/SUNROOF/OPENING TRIM LACE -REMOVAL).
5. Remove control switch. (Refer to BODY/ SUNROOF/CONTROL SWITCH).
6. Disconnect wire harness.
7. Remove headliner
8. Disconnect the drain tubes from sunroof housing.
Sunroof Module Assembly
9. Loosen fasteners attaching sunroof module assembly.
10. With the aid of a helper, remove fasteners attaching sunroof module assembly to roof panel.
INSTALLATION
NOTE: There are locating pins on the roof panel near the front corners of the sunroof opening that will help position the sunroof module correctly.
1. With the Glass panel in the fully closed position.
2. Raise rear end of sunroof module assembly and guide into position and start fasteners.
3. Tighten the fasteners holding the sunroof module to roof panel. Tighten the fasteners to 11 Nm (97 in. lbs.) torque.
4. Connect the drain tubes to the sunroof housing.
5. Connect wire harness.
6. Set headliner into position.
7. Connect battery negative cable.
8. Connect express module, drive motor, and control switch wire connectors.
9. Test sunroof operation, adjust as necessary.
10. Finish installing the headliner.
11. Install sunroof opening trim lace.
