Sebring Convertible V6-2.5L SOHC 24 Valve (1996)
Fig. 13 EGR Tube And Right Plenum Support Bolt
13. Remove EGR tube from intake plenum Fig. 13.
14. Remove plenum support bracket bolt located rearward of EGR tube Fig. 13.
15. Remove 7 bolts holding upper intake plenum and remove plenum.
16. Disconnect electrical connectors from fuel injectors.
Fig. 13 EGR Tube And Right Plenum Support Bolt
17. Remove 4 bolts holding fuel rail Fig. 14.
Fig. 15 Fuel Rail Spacers
18. Lift fuel rail off engine. There are spacers under each fuel rail bolt Fig. 15.
INSTALLATION
1. Apply a light coating of clean engine oil to the 0-ring on the nozzle end of each injector.
CAUTION: Make sure spacers are located under each fuel rail mounting position.
2. Insert fuel injector nozzles into openings in intake manifold. Seat the injectors in place. Tighten fuel rail bolts to 12 Nm (8 ft. lbs.).
3. Attach electrical connectors to fuel injectors.
4. Connect fuel supply tube to fuel rail. See: Service and Repair
5. Install new gasket and position upper intake plenum. Tighten plenum bolts to 18 Nm (13 ft. lbs.) torque.
6. Install bolts at plenum support brackets. Tighten bolts to 18 Nm (13 ft. lbs.).
7. Install EGR tube to plenum. Tighten EGR tube to intake manifold plenum screws to 11 Nm (95 in. lbs.) torque.
8. Install throttle cables.
