Sebring Convertible V6-2.5L SOHC 24 Valve (1996)
NOTE:
THE TIP OF THE TERMINAL CLIP MUST FACE OUTBOARD. CLIPS ARE PRE-SOLDERED AND FLUXED. DO NOT REUSE A CLIP IF
IT HAS BEEN HEATED PREVIOUSLY.
7.
Place the solder gun on the new terminal clip and heat until the solder flows. Remove the solder gun and continue to hold the clip in position for 5
seconds. Let the solder area cool for 10 minutes, (Fig. 3).
8.
Attach the wire connector to the terminal clip.
9.
Repeat the procedure on the other side of the rear window if the tip of the terminal clip is not facing outboard or the clip has broken or the clip has
come loose from the glass.
10.
Test the rear window defogger grid for continuity. If successful perform step 11, if not, additional grid diagnosis will be necessary.
11.
Install the headliner straps to the carpet using the original screws.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
